HP FlexNetwork MSR2003 User Manual

47
Step Command Remarks
3. Specify the IP address of the
primary network calling
processor.
voice-config ncp-ip
ip-address
By default, no primary network
calling processor is specified.
After you configure this command,
the other Option 184 parameters
take effect.
4. (Optional.) Specify the IP address
for the backup server.
voice-config as-ip
ip-address
By default, no backup network
calling processor is specified.
5. (Optional.) Configure the voice
VLAN.
voice-config voice-vlan
vlan-id {
disable
|
enable
}
By default, no voice VLAN is
configured.
6. (Optional.) Specify the failover IP
address and dialer string.
voice-config fail-over
ip-address dialer-string
By default, no failover IP address or
dialer string is specified.
Customizing DHCP options
IMPORTANT:
Use caution when customizing DHCP options because the configuration might affect DHCP
operation.
You can customize options for the following purposes:
• Add newly released options.
• Add options for which the vendor defines the contents, for example, Option 43.
• Add options for which the CLI does not provide a dedicated configuration command. For
example, you can use the option 4 ip-address 1.1.1.1 command to define the time server
address 1.1.1.1 for DHCP clients.
• Add all option values if the actual requirement exceeds the limit for a dedicated option
configuration command. For example, the dns-list command can specify up to eight DNS
servers. To specify more than eight DNS servers, you must use the option 6 command to
define all DNS servers.
To customize a DHCP option in a DHCP address pool:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP address
pool and enter its view.
dhcp server ip-pool
pool-name
By default, no DHCP address pool exists.
3. Customize a DHCP
option.
option
code {
ascii
ascii-string |
hex
hex-string |
ip-address
ip-address&<1-8> }
By default, no DHCP option is customized in a
DHCP address pool.
DHCP options specified in DHCP option
groups take precedence over those specified in
DHCP address pools.
To customize a DHCP option in a DHCP option group:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Create a DHCP user
class and enter DHCP
user class view.
dhcp class
class-name
By default, no DHCP user class
exists.

HP FlexNetwork MSR2003 Specifications

General

Brand	HP
Model	FlexNetwork MSR2003
Category	Network Router
Language	English