13-69
Configuring for Network Management Applications
LLDP (Link-Layer Discovery Protocol)
Displaying Switch Information Available for Outbound
Advertisements
These commands display the current switch information that will be used to
populate outbound LLDP advertisements.
For example, in the default configuration, the switch information currently
available for outbound LLDP advertisements appears similar to the display in
Figure 13-18 on page 13-70.
Syntax show lldp info local-device [ port-list ]
Without the [ port-list ] option, this command displays the global
switch information and the per-port information currently
available for populating outbound LLDP advertisements.
With the [ port-list ] option, this command displays only the
following port-specific information that is currently available for
outbound LLDP advertisements on the specified ports:
• PortType
• PortId
• PortDesc
Note: This command displays the information available on the
switch. Use the lldp config < port-list > command to change the
selection of information that is included in actual outbound
advertisements. In the default LLDP configuration, all
information displayed by this command is transmitted in
outbound advertisements.
To Next Page
Loading...
Need help?
General