A-32
File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
Figure A-12. Example of Sending Event Log Content to a File on an Attached PC
Copying Crash Data Content to a Destination Device
This command uses TFTP, USB, or Xmodem to copy the Crash Data content
to a destination device. You can copy individual slot information or the
management module’s switch information. If you do not specify either, the
command defaults to the management function’s data.
For example, to copy the switch’s crash data to a file in a PC:
Figure A-13. Example of Copying Switch Crash Data Content to a PC
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Syntax: copy crash-data [master>] tftp <ip-address> <filename>
copy crash-data [mm>] usb <filename>
copy crash-data [mm>] xmodem
where: mm Retrieves crash log or crash data from the switch’s
chassis processor. When “mm” is specified,
crash files from both management modules are
copied.
These commands copy the crash data content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy the management module (mm)
switch information. If you do not specify either, the command
defaults to the mm data.
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
To Next Page
Loading...
Need help?
General