To Next Page

To Previous Page

4-19

Using the Command Line Interface (CLI)

CLI Control and Editing

Figure 4-12. Example of Using the Alias Command with show int custom

Note Remember to enclose the command being aliased in quotes.

Command parameters for the aliased command can be added at the end of the

alias command string. For example:

ProCurve(config)# alias sc “show config”

ProCurve(config)# sc status

To change the command that is aliased, re-execute the alias name with new

command options. The new options are used when the alias is executed.

To display the alias commands that have been configured, enter the show alias

command.

ProCurve(config)# show int custom 1-4 port name:4 type vlan intrusion speed

enabled mdi

Status and Counters - Custom Port Status

Intrusion

Port Name Type VLAN Alert Speed Enabled MDI-mode

---- ---------- ---------- ----- --------- ------- ------- --------

1 Acco 100/1000T 1 No 1000FDx Yes Auto

2 Huma 100/1000T 1 No 1000FDx Yes Auto

3 Deve 100/1000T 1 No 1000FDx Yes Auto

4 Lab1 100/1000T 1 No 1000FDx Yes Auto

ProCurve(config)# alias sic “show int custom 1-4 port name:4 type vlan intrusion

speed enabled mdi”

ProCurve(config)#

ProCurve(config)# sic