Installing and configuring the Edge Switch 2/2464
Using HAFM from a remote location
Use this section to install the HAFM client on a remote workstation.
Remote workstation minimum requirements
The minimum requirements described in ”Minimum remote workstation requirements” on page 19
must be met to install HAFM on a remote workstation.
NOTE: For HAFM to function properly, compatible versions must be installed on both the client
machines and the HAFM appliance.
Install HAFM client on a remote workstation
Use these steps to install HAFM on a remote client:
1. Verify that the workstation and the Ethernet LAN segment (with the Edge Switch 2/24 attached)
are connected through the Internet.
2. At the workstation, launch the browser application.
3. At the browser, enter the HAFM appliance IP address.
4. The HAFM splash screen is displayed with the following options, see Figure 33.
a. Install HAFM remote client application—Select this option to install the application for your
workstation platform.
b. Download SNMP MIB files—The Management Information Base (MIB) files are provided in
standard ASN.1 syntax and may be installed into the MIB database of any
SNMPv2-compliant Network Management Station.
Figure 33 HAFM remote client install
To Next Page
Loading...
Need help?
General