HP V1910 Switch Series User Manual

125
Figure 109 Add a target host of SNMP traps
Table 47 Configuration items for adding a target host
Item Descri
p
tion
Destination IP Address
Set the destination IP address.
Select the IP address type: IPv4 or IPv6, and then type the corresponding IP
address in the text box according to the IP address type.
Security Name
Set the security name, which can be an SNMPv1 community name, an
SNMPv2c community name, or an SNMPv3 user name.
UDP Port
Set UDP port number.
IMPORTANT:
The default port number is 162, which is the SNMP-specified port used for
receiving traps on the NMS. Generally (such as using iMC or MIB Browser as the
NMS), you can use the default port number. To change this parameter to another
value, you need to make sure that the configuration is the same with that on the
NMS.
Security Model
Select the security model, that is, the SNMP version. Ensure that the SNMP
version is the same with that on the NMS; otherwise, the NMS cannot receive
any trap.
Security Level
Set the authentication and privacy mode for SNMP traps when the security
model is selected as v3. The available security levels are: no authentication no
privacy, authentication but no privacy, and authentication and privacy.
When the security model is selected as v1 or v2c, the security level is no
authentication no privacy, and cannot be modified.
Return to SNMPv1 or SNMPv2c configuration task list or SNMPv3 configuration task list.
SNMP configuration example
Network requirements
 As shown in Figure 110, the NMS connects to the agent, Switch, through an Ethernet.

HP V1910 Switch Series Specifications

General

Brand	HP
Model	V1910 Switch Series
Category	Switch
Language	English