General Query Source
IP
Specify the source IP address of general queries. HP recommends you to configure a
non-all-zero IP address as the source IP address of IGMP queries.
Special Query Source
IP
Specify the source IP address of group-specific queries. HP recommends you to
configure a non-all-zero IP address as the source IP address of IGMP queries
Return to Configuration task list.
Configuring IGMP snooping port functions
Select Network > IGMP Snooping in the navigation tree to enter the basic configuration page and then
click the Advanced tab to enter the page shown in Figure 215.
Figure 215 Advanced configuration
Table 102 Configuration items for advanced IGMP snooping features
Item Descri
tion
Port
Select the port on which advanced IGMP snooping features are to be configured. The port
can be an Ethernet port or Layer-2 aggregate port.
After a port is selected, advanced features configured on this port are displayed at the
lower part of this page.
IMPORTANT:
Advanced IGMP snooping features configured on a Layer 2 aggregate port do not interfere
with features configured on its member ports, nor do they take part in aggregation
calculations; features configured on a member port of the aggregate group will not take
effect until it leaves the aggregate group
VLAN ID
Specify a VLAN in which you can configure the fast leave function for the port or the
maximum number of multicast groups allowed on the port.
Configurations made in a VLAN take effect for the ports in this VLAN only.
To Next Page
Loading...
Need help?
General