HP V1910 Switch Series User Manual

334
Configuration procedure
1. Configure the IP addresses of the interfaces. (Omitted)
2. Configure the RADIUS scheme system
# Configure the RADIUS authentication server.
 From the navigation tree, select Authentication > RADIUS. The RADIUS server configuration page
appears.
Figure 302 RADIUS authentication server configuration
 Select Authentication Server as the server type.
 Enter the primary server IP address 10.1.1.1.
 Enter the primary server UDP port number 1812.
 Select active as the primary server status.
 Click Apply.
# Configure the RADIUS accounting server.
Figure 303 RADIUS accounting server configuration
 Select Accounting Server as the server type.

HP V1910 Switch Series Specifications

General

Brand	HP
Model	V1910 Switch Series
Category	Switch
Language	English