EasyManuals Logo
Home>Hypertherm>Cutter>HyPerformance Plasma HPR800XD

Hypertherm HyPerformance Plasma HPR800XD User Manual

Hypertherm HyPerformance Plasma HPR800XD
366 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #335 background imageLoading...
Page #335 background image
Appendix B – CnC interfACe protoCol
HPR800XD Auto Gas806500 b-3
Pierce Complete Input When active, the system will use shield preflow gases during
piercing. When the signal is removed, the system will switch to shield
cutflow gases. The signal should be applied at the same time the
start signal is applied.
Corner Current Input When active, the system will switch to user specified corner current.
Remote Power Input Used to turn the power on or off
Not Ready for Start Output When on, this signal indicates that the plasma system is not ready for
a plasma start signal. This could be because the system is purging or
in test gas mode.
Ramp-down Error Output Indicates the arc did not ramp-down properly. Consumable life is
shortened.
TX+ Serial Transmitting from the system
Connect to CNC RX+
TX– Serial Transmitting from the system
Connect to CNC RX–
RX+ Serial Receiving by the system
Connect to CNC TX+
RX– Serial Receiving by the system
Connect to CNC TX–
Signal list (continued)
Signal name Type Description
Hardware
Inputs active low, dry contact, opto-isolated
Inactive: 24 V or open circuit, 0 mA
Active: 0 V or closed contact (0 ohm min, 6.5 mA; 200K ohm max, 0.1 mA)
Outputs active low, open collector, opto-isolated
Inactive: Up to 40 V open circuit/open collector, 0 mA
Recommended 24 V pull-up into high impedance load
Active: 0.3 V max output into high impedance load, sinking capacitor up to 5 mA
Or 2k ohm minimum load resistance
Serial RS422 serial communications

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hypertherm HyPerformance Plasma HPR800XD and is the answer not in the manual?

Hypertherm HyPerformance Plasma HPR800XD Specifications

General IconGeneral
BrandHypertherm
ModelHyPerformance Plasma HPR800XD
CategoryCutter
LanguageEnglish

Related product manuals