Hypertherm HyPerformance Plasma HPR800XD User Manual

InstallatIon
HPR800XD Auto Gas – 806500 3-3
Upon receipt
• Verifythatallsystemcomponentsonyourorderhavebeenreceived.Contactyoursupplierifanyitems
are missing.
• Inspectthesystemcomponentsforanyphysicaldamagethatmayhaveoccurredduringshipping.Ifthereis
evidence of damage, refer to Claims. All communications regarding claims must include the model number and
serial number located on the rear of the power supply.
Claims
Claims for damage during shipment – If your unit was damaged during shipment, you must file a claim with the
carrier. Hypertherm will furnish you with a copy of the bill of lading upon request. If you need additional assistance,
callCustomer Service listed in the front of this manual, or your authorized Hypertherm distributor.
Claims for defective or missing merchandise – If any of the merchandise is defective or missing, contact your
supplier. If you need additional assistance, call Customer Service listed in the front of this manual, or your authorized
Hypertherm distributor.
Installation requirements
All installation and service of the electrical and plumbing systems must conform to national and local
electrical and plumbing codes. This work should be performed only by qualified, licensed personnel.
Direct any technical questions to the nearest Hypertherm Technical Service Department listed in the front of this manual,
or your authorized Hypertherm distributor.
Noise levels
Acceptable noise levels as defined by national and local codes may be exceeded by this plasma system. Always
wear proper ear protection when cutting or gouging. Any noise measurements taken are dependant on the specific
environment in which the system is used. See also Noise can damage hearing in the Safety section of this manual.
Specific information by product can be found in the Hypertherm downloads library at:
https://www.hypertherm.com/Xnet/library/DocumentLibrary.jsp
Select the product you are looking for from the Product Type drop down menu, choose “Regulatory” from the Category
drop down menu, and choose “Acoustical Noise Data Sheets” from the Sub Category drop down menu. Hit Submit.
Placement of system components
• Placeallsystemcomponentsinpositionpriortomakingelectrical,gas,andinterfaceconnections.Usethe
diagram in this section for component-placement guidelines.
• Groundallsystemcomponentstoearth.SeeRecommended grounding and shielding practices in this section
for details.
• Topreventleaksinthesystem,tightenallgasandwaterconnectionsasshownbelow:
Torque specifications
Gas or water hose
size kgf-cm lbf-in lbf-ft
Up to 10 mm (3/8 in) 8.6-9.8 75-85 6.25-7
12 mm (1/2 in) 41.5-55 360-480 30-40

Hypertherm HyPerformance Plasma HPR800XD Specifications

General

Brand	Hypertherm
Model	HyPerformance Plasma HPR800XD
Category	Cutter
Language	English