Hypertherm SYNC Powermax 85 User Manual

Complete Regular Maintenance Tasks
7
Powermax65/85/105 SYNC Operator Manual 810470 173
 Replace the air filter bowl and O-ring as necessary. Refer to the
Powermax65/85/105 SYNC Parts Guide (810490). Also refer to Replace the air filter bowl,
O-ring, and filter element on page 173.
 If you use an external filtration system, such as the Eliminizer filter kit, also do a check of that
filter regularly for necessary maintenance or cleaning.
Examine the filter element
 Do a check of the filter element inside the
air filter bowl regularly, especially in
environments that are very dusty or very
warm and humid.
 Replace the filter element when it is dirty or
starts to deteriorate. Refer to the
Powermax65/85/105 SYNC Parts Guide
(810490). Also refer to Replace the air filter
bowl, O-ring, and filter element on
page 173.
Replace the air filter bowl, O-ring, and filter element
1. To replace the filter element, twist and pull the plastic fittings away from the filter element,
approximately a 1/4 turn. Set the fittings aside. Discard the used filter element.
2. Put the new air filter element in the plastic fittings. Twist the plastic fittings until they lock
together, approximately a 1/4 turn.
3. To replace the O-ring, discard the used O-ring, and put the new O-ring at the top of the filter
bowl.
4. To replace the air filter bowl, discard the used air filter bowl.
Clean filter element
1
1

Hypertherm SYNC Powermax 85 Specifications

General

Brand	Hypertherm
Model	SYNC Powermax 85
Category	Welding System
Language	English