Hypertherm SYNC Powermax 85 User Manual

Cut with the Hand Torch
4
Powermax65/85/105 SYNC Operator Manual 810470 97

For help installing the cartridge, refer to Step 3 – Install the cartridge on
page 66.
Prepare to fire the torch
WARNING
INSTANT-ON TORCHES – PLASMA ARC CAN CAUSE INJURY, BURNS
Ignition of the plasma arc occurs immediately when you pull the torch trigger. Before
changing the cartridge, one of the following steps is necessary. Whenever possible,
complete the first step.
 Set the power switch on the plasma power supply to OFF (O).
OR
 Move the torch-lock switch to the yellow lock (X) position. Pull the trigger to make
sure that the torch does not fire a plasma arc.
WARNING
INSTANT-ON TORCHES – STAY CLEAR OF PLASMA ARC
The plasma arc will cut quickly through gloves and skin.
 Put on correct and approved protective equipment.
 Keep hands, clothing, and objects away from the torch tip.
 Do not hold the workpiece. Keep your hands clear of the cutting path.
 Never point the torch toward yourself or others.
WARNING
RISK OF BURNS AND ELECTRIC SHOCK – USE INSULATED GLOVES
Always put on insulated gloves when changing the cartridges. The cartridges
get very hot during cutting and can cause severe burns.
Touching the cartridges can also cause electric shock if the plasma power
supply is ON and the torch-lock switch is not in the yellow lock (X) position.

Hypertherm SYNC Powermax 85 Specifications

General

Brand	Hypertherm
Model	SYNC Powermax 85
Category	Welding System
Language	English