Memory
Notes:
1. The system board requires gold-plated SIMMs.
2. SIMMs must be set in the Setup Utility for correct parity setting. When
removing or installing a SIMM, run the Setup Utility (and set the date
and time) to clear any XX62 errors. See “POST Error Codes” on
page 2-3.
001
– Power off the system unit.
– Ensure all SIMMs are seated correctly.
– Insert the Advanced Diagnostics diskette into drive A.
– Power on the system unit.
– Note any messages, error codes, or symptoms. Disregard 164 errors
(memory size).
DID YOU RECEIVE A 201 or 203 POST ERROR?
Yes No
002
DID YOU RECEIVE A 229 ERROR?
Yes No
003
Go to Step 006 on page 2-31.
004
Note: The system board has pluggable cache modules; continue with
the following steps to determine whether to replace the cache
memory modules or the system board.
– Remove and replace the system board cache memory modules one
bank at a time until the error goes away.
005
– Press 0 (SYSTEM CHECKOUT), then press Enter.
– Press Y when the Installed Devices list appears.
– Select the 0 (RUN TESTS ONE TIME) option, then press Enter.
(Step 005 continues)
2-30
To Next Page
Loading...
Need help?
General