Installing the paper transport frame on the main frame
This section provides the information needed to install the paper transport frame on to the printers main
frame of a fiscal or fiscal ready printer.
To install the paper transport frame on the main frame, complete the following steps:
1. Position the transport frame over the main frame.
2. Align the rear of transport frame with the pivot points on the main frame; then, press the front of the
transport frame down onto the main frame until it clicks into place.
3. Use a screw (A in Figure 38 on page 66) to secure the ground strap (C in Figure 38 on page 66)
and the two frames.
4. Install the logic card on the printer unit; then, install all the covers you removed.
5. Install both the paper door and main covers (see “Installing the paper door cover” on page 42 and
“Installing the main cover” on page 46 for instructions).
6. If necessary, install the fiscal tray (see “Installing the fiscal tray” on page 29).
7. Reconnect the external cables and power cords; then, turn on the printer.
Removing and replacing FRUs
Chapter 5. Removing and replacing FRUs 67
To Next Page
Loading...
Need help?
General
