17
SET MODE
17-15
Previous view
RX Call Sign SPEECH (Default: ON (Kerchunk))
SPEECH > RX Call Sign SPEECH (RX Call Sign
SPEECH)
Turn the RX call sign speech function ON or OFF for
calls received in the DV mode.
• OFF: No announcement is made even
when a call is received.
• ON (Kerchunk): The caller station’s call sign is an-
nounced only when it makes a short
transmission.
• ON (All): The caller station’s call sign is always
announced.
NOTE:
• When the digital squelch function is used, the call-
ing station’s call sign is not announced if the re-
ceived signal is not addressed to your call sign, or
does not include an unmatched digital code.
• When the repeater returns “UR?” or “RPT?,” the
calling station’s call sign is not announced.
• When a call is received during scanning, the scan
resumes even while the transceiver announcing.
• A “/” or a note after a call sign are not announced.
• When a call is received during an announcement,
the received audio is heard after cancelling the an-
nouncement.
RX>CS SPEECH (Default: ON)
SPEECH > RX>CS SPEECH (RX>CS SPEECH)
Turn the RX>CS Speech function ON or OFF.
The RX>CS Speech function announces the station
call sign that is selected from a Received Call Record
by holding down
AUTO TUNE
RX
CS
. (p. ??-??)
• OFF: The station call sign is not announced.
• ON: The station call sign is announced.
S-Level SPEECH (Default: ON)
SPEECH > MODE SPEECH (MODE SPEECH)
Turn the Signal strength level Speech function ON or
OFF.
• OFF: Only the operating frequency is announced.
• ON: The operating frequency and the signal strength
level are announced.
MODE SPEECH (Default: OFF)
SPEECH > MODE SPEECH (MODE SPEECH)
Turn the Operating Mode Speech function ON or OFF.
When this function is ON, the selected operating mode
is announced when the mode switch is pushed.
• OFF: The selected operating mode is not an-
nounced.
• ON: The selected operating mode is announced.
SPEECH Language (Default: English)
SPEECH > SPEECH Language (SPEECH Language)
Set the desired announcement language to English or
Japanese.
Alphabet (Default: Normal)
SPEECH > Alphabet (Alphabet)
Select either “Normal” or “Phonetic Code” to announce
the alphabet character.
• Normal: Normal code is used. (for example: A
as eh, B as bee)
• Phonetic Code: Phonetic code is used. (for example:
A as Alfa, B as Bravo)
SPEECH Speed (Default: Fast)
SPEECH > SPEECH Speed (SPEECH Speed)
Set the speech speed to Low (slow) or High (fast).
SPEECH Level (Default: 50%)
SPEECH > SPEECH Level (SPEECH Level)
Enter a volume level number between 0% (no voice),
1% (minimum) and 100% (maximum) for the voice syn-
thesizer.
The voice synthesizer audio output level from the
speaker is linked with [AF] setting from the minimum
audio volume up to the set level.
SPEECH Set mode
To Next Page
Loading...
Need help?
General
