N Memory scan
IMPORTANT!: To perform memory scan, 2 or more mem-
ory channels MUST be programmed, otherwise the scan
will not start.
q Push [M/CALL] several times to select memory mode.
w Set the squelch level.
e Push and hold [SCAN](V/MHz) for 1 sec. to enter the scan-
ning type selection.
r Rotate [DIAL] to select the desired scanning type.
• “ALL” for all memory scan; “BAND” for band memory scan,
“MODE” for mode scan, “DUP” (appears only when duplex op-
eration is set) for duplex scan.
[DIAL]
All memory scan
Band memory scan
Mode scan
Push and hold
for 1 sec.
Duplex scan
Rotate
Selected mode is displayed.
t Push [V/MHz] to start the scan.
• Scan pauses when a signal is received.
• Rotate [DIAL] to change the scanning direction. This also
causes the transceiver to resume scanning.
• Push [V/MHz] to stop the scan.
During memory scan During mode scan
Band memory scan function: Repeatedly scans all
memory channels programmed with any frequencies of
the band programmed in the memory channel selected for
scanning.
Mode scan function: Repeatedly scans all memory chan-
nels in which the same operating mode as the selected
memory channel has been programmed.
Duplex scan function: Repeatedly scans two frequencies
(transmission/reception) during duplex scan operation.
106
10
SCAN OPERATION
To Next Page
Loading...
Need help?
General
