153
13
OTHER FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
[DIAL]
Tone scan for repeater tone
Tone scan for tone squelch
Tone scan for DTCS squelch
t Push [V/MHz] to stop the scan.
• If the scan is cancelled before the transceiver detects the tone
or code, the set mode contents are not changed.
• The detected tone is used for temporary operation only. The
stored tone setting in memory or call channel won’t be changed.
NOTE: Tone frequency is over-written automatically when it cor-
responds with the scanning tone frequency in tone squelch mode.
However, it is not over-written in memory or call channel mode.
N Beep tones
You can select to have confirmation beeps sound at the
push of a switch. The output level can be adjusted within 39
levels with “BEEPLV” in SOUNDS set mode (SET).
MENU ¶ SOUNDS ¶ BEEPLV
(p. 130)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
You can select silent operation by turning beep tones OFF
with “KEY B” in SOUNDS set mode (SET).
MENU ¶ SOUNDS ¶ KEY B
(p. 130)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
N Dial speed acceleration
The dial speed acceleration automatically speeds up the
tuning dial speed when rotating [DIAL] rapidly.
This function can be turned ON and OFF with “DIAL S”
(DIAL SPEED) in FUNC set mode (SET).
MENU ¶ SET ¶FUNC ¶ DIAL S
(p. 126)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
To Next Page
Loading...
Need help?
General
