68
7
DV MODE OPERATION
N Message operation
D TX message programming
TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters.
q Enter “TX MSG” in MESSAG (message) screen.
MENU ¶ MESSAG ¶ TX MSG
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
• TX MSG screen is displayed.
w Push [](2) or [](8) to select the desired transmit mes-
sage channel.
• TM1 to TM5 and OFF are available.
• Previously message is displayed if programmed.
e Push [](6) to select the message edit condition.
• The 1st digit of the message blinks.
r Push [ ](2) or [](8) to select the desired character or
symbol.
• If an unwanted character is entered, push [](6) or [](4) to
select the character, then push [CLR](1) to erase the selected
character, or push and hold [CLR](1) for 1 sec. to erase all char-
acters following the cursor.
• Push [](6) to move the cursor right; push [](4) to move the
cursor left.
t Repeat step r to enter the desired message.
• Up to 20 character messages can be set.
y Push [ ](5) to store the message.
u Push
[MENU ] to return to the frequency screen.
• Available characters
(A) (B) (C) (D) (E) (F) (G) (H) (
I
) (J)
(Space)
(K) (L) (M)
(N) (O) (P) (Q) (R) (S) (T) (U) (V) (W)
(9)(0) (1) (2) (3) (4) (5) (6) (7) (8)
(
+
)
(
”
)(
!
) (#) ($) (%) (&) (
’
)
(
.
)(
:
)(
;
)(
=
) (?) (@) (
[
)(
\
)(
]
)(
^
)
(
(
)(
)
)(
)
(X) (Y) (Z)
(
,
)(
-
)
(
/
)(
<
)(
>
)
To Next Page
Loading...
