155
13
OTHER FUNCTIONS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
N Auto power OFF
The transceiver can turn itself OFF automatically after a
specified time. Activating a control restarts the time-out. The
transceiver beeps before turning OFF.
120 min., 90 min., 60 min., 30 min. and OFF can be specified.
The specified period is retained even when the transceiver
is turned OFF by the auto power-off function. To cancel the
function, select “OFF” in the auto power-off item in set mode.
This can be selected with “AP OFF” in FUNC set mode
(SET).
MENU ¶ SET ¶ FUNC ¶ AP OFF
(p. 128)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
N Auto power ON
The transceiver can be set to automatically turn ON after a
specified period. The timer can be selected within 30 min. to
24 hrs. in 30 min. steps. Once this timer turns the transceiver
power ON, the auto power-on is automatically cancelled.
This can be selected with “AP ON” in FUNC set mode (SET).
MENU ¶ SET ¶ FUNC ¶ AP ON
(p. 128)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
When operating with battery pack or case and the battery
is exhausted, auto power-on does not function.
During standby, a small current still flows in the radio.
N Time-out timer
To prevent accidental prolonged transmission, etc., the
transceiver has a time-out timer. This timer cuts a trans-
mission OFF after 1, 3, 5, 10, 15 or 30 min. of continu-
ous transmission. This timer can be cancelled (default).
Approx. 10 sec. before the time-out timer is activated, the
transceiver emits a beep tone as a warning.
This can be selected with “TOT” in FUNC set mode (SET).
MENU ¶ SET ¶ FUNC ¶ TOT
(p. 126)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
N PTT lock
To prevent accidental transmission, etc., the transceiver has
a PTT lock function.
This can be selected with “PTT LK” in FUNC set mode
(SET).
MENU ¶ SET ¶ FUNC ¶ PTT LK
(p. 125)
(Push [MENU ]), (Push [](2)/[](8), then push [ ](5).)
To Next Page
Loading...
Need help?
General
