8
XP652 MANUAL Table of Contents
TABLE OF CONTENTS
I. INTRODUCTION
1. Using This Manual 9
2. Features 9
2.1 Transmitter 9
2.2 Receiver 9
2.3 Servos 10
3. Specifications 11
3.1 System Specifications 11
3.2 Transmitter Specifications 11
3.3 Servo Specifications 11
3.4 Receiver Specifications 12
3.5 Charger Specifications 12
3.6 Airborne Battery Pack 12
4. Battery Charging 14
4.1 Transmitter/Receiver 14
4.2 Charger 14
5. Trainer System 14
II. AIRPLANE SECTION
1. Transmitter Controls 15
1.1 Control Identification and Location 15
1.2
Receiver Channel Assignment/Transmitter Throttle ATL
15
1.3 Transmitter Rear 16
1.4 Control Stick Length Adjustment 17
1.5 Direct Servo Control (DSC) 17
1.6 Neck Strap Attachment 17
2. Connections 18
2.1 Installation Requirements 18
2.2 Connections 18
3. Key Input and Display 19
4. Battery Alarm and Display 19
5. Input Mode and Function 20
5.1 Normal Display 20
5.2 System Mode 20
5.3 Function Mode 21
6. Functions (System Mode) 22
6.1 Model Type Selection 22
6.2 Data Reset 23
6.3 Dual Rate Switch Selection 24
6.4 Wing Type Selection 25
6.5 Model Selection 27
6.6 Model Name Entry 28
6.7 Modulation Select 29
6.8 Fail-Safe/Hold 30
6.9 Fail-Safe (Z-PCM) 30
6.10 Fail-Safe (S-PCM) 32
7. Functions (Function Mode) 34
7.1 Servo Reversing 34
7.2 Dual Rate 35
7.3 Exponential 36
7.4 Sub-Trim 37
7.5 Travel Adjustment 38
7.6 Aileron to Rudder Mixing 39
7.7 Elevator to Flap Mixing 41
7.8 Differential 43
7.9 Flap to Elevator Offset Trim 44
7.10 Programmable Mixing (A, B, C) 45
7.11 Trim Offset 48
8. Data Sheets 51
III. HELICOPTER SECTION
1. Transmitter Controls 52
1.1 Control Identification and Location 52
1.2
Receiver Channel Assignment/Transmitter Throttle ATL 52
1.3 Transmitter Rear 53
1.4 Control Stick Length Adjustment 54
1.5 Direct Servo Control (DSC) 54
1.6 Neck Strap Attachment 54
2. Connections 55
2.1 Installation Requirements 55
2.2 Connections 55
3. Key Input and Display 56
4. Battery Alarm and Display 56
5. Input Mode and Function 57
5.1 Normal Display 57
5.2 System Mode 57
5.3 Function Mode 58
6. Functions (System Mode) 59
6.1 Model Type Selection 59
6.2 Data Reset 60
6.3 Dual Rate Switch Selection 61
6.4 Gear/Gyro Switch Selection 62
6.5 Model Selection 63
6.6 Model Name Entry 64
6.7 Modulation Select 65
6.8 Fail-Safe/Hold 66
6.9 Fail-Safe (Z-PCM) 66
6.10 Fail-Safe (S-PCM) 68
7. Functions (Function Mode) 70
7.1 Servo Reversing 70
7.2 Dual Rate 71
7.3 Exponential 72
7.4 Sub-Trim 73
7.5 Travel Adjustment 74
7.6 Throttle Hold 75
7.7 Pitch Curve 76
7.8 Throttle Curve 77
7.9 Revolution Mixing 78
7.10 Rudder Offset 79
7.11 Programmable Mixing (A) 80
7.12 Stunt Trim 83
7.13 CCPM Swashplate mixing 84
7.14 Trim Offset Memory 86
8. Data Sheets 89
8.1 Ergo .32/.46 Initial Setup 89
8.2 Ergo .46 Initial Setup w/3D Pitch Curve 90
8.3 Ergo .60 Initial Setup 91
8.4 Blank Data Sheet 92
IV. IMPORTANT INFORMATION
1. General Notes 93
2. Daily Flight Checks 93
3. Warranty Coverage 94
4. Repair Service Instructions 94
5. Frequency Chart 95
To Next Page
Loading...
Need help?
General
