KE-2050/KE-2060, KE-2050R/2055R/KE-2060R Maintenance Manual
2-15
Rev. 2.00
2-3-2. FMLA Head
(1) Remove the peripheral components
following the steps (1), (2), (4) and (7) in
the section 2-1-2.
(2) Remove the Z-sensor base IC mounting
screws
19
(2 pcs.) and detach the
Z-sensor base IC downward.
(3) Cut the tie-up band to replace the
Z-sensor.
(4) Reassemble the components in the
reverse order of assembly.
⑲
(5) Check following the procedure below and
make adjustments if necessary.
Figure 2-3-4
Figure 2-3-5
Figure 2-3-6
To Next Page
Loading...
Need help?
General
