KE-2050/KE-2060, KE-2050R/2055R/KE-2060R Maintenance Manual
5-3
Rev. 2.00
5-3. Replacing the IN and OUT Motors
(1) Disconnect the connector of the motor relay cable.
(2) Loosen the screws fixing the motor bracket A to detach the drive belt from the motor pulley A.
(3) Detach the motor and gear head.
(4) If you have detached the motor pulley A from the gear head, install a new motor so that the end
of the motor (gear head) shaft sinks below the end of the motor pulley A.
M size: A = 5.5 mm ± 0.2 mm
L size: A = 6.2 mm ± 0.2 mm
To Next Page
Loading...
Need help?
General
