Juniper CTP2000 Series Hardware Documentation

When you power on the device, the CLI appears on your console's screen. You can
begin configuration.
Related
Documentation
Setting Up Management Access on the CTP2000 Platform on page 111•
• CTP2000 Console Port Setup on page 112
• Using HyperTerminal with the CTP2000 Platform on page 113
• CTP2000 Platform SSH Setup on page 114
CTP2000 Platform SSH Setup
When you have configured an IP address for the CTP2000 device, you can run SSH from
a host to access the device through its Ethernet port. To connect the Ethernet port to
the network:
1. Connect an RJ-45 cable to one of the two Ethernet ports of the CTP2000 chassis.
This applies to the AC and DC power versions of the platform.
2. Connect the other end of the cable to the appropriate Ethernet network for an
out-of-band connection.
CAUTION: Do not change the IP address for the Ethernet interface that you
are using to communicate with the device. If you change the address, you
will lose the SSH session.
Related
Documentation
• Setting Up Management Access on the CTP2000 Platform on page 111
• CTP2000 Console Port Setup on page 112
• Using HyperTerminal with the CTP2000 Platform on page 113
• Connecting Directly to the CTP2000 Platform on page 113
Copyright © 2017, Juniper Networks, Inc.114
CTP2000 Hardware Documentation

Juniper CTP2000 Series Specifications

General

Brand	Juniper
Model	CTP2000 Series
Category	Network Hardware
Language	English