Juniper CTP2000 Series Hardware Documentation

Table 14: CTP2000 4WE&M RTM Pinouts–Connector B (continued)
Connector B
PINSignalSignalPIN
33Port 5 MPort 5 SB8
34Port 6 TPort 6 R9
35Port 6 T1Port 6 R110
36Port 6 EPort 6 SG11
37Port 6MPort 6 SB12
38Port 7 TPort 7 R13
39Port 7 T1Port 7 R114
40Port 7 EPort 7 SG15
41Port 7 MPort 7 SB16
50GNDGND25
Related
Documentation
CTP2000 4WE&M Interface Module on page 14•
• CTP2000 FXS and FXO Interface Module Cables and Pinouts on page 45
• CTP2000 Series Console Cable Pinouts on page 58
CTP2000 FXS and FXO Interface Module Cables and Pinouts
•
Required Cables on page 45
•
RTM Pinout Locations on page 45
•
FXS Connector Pinouts on page 46
•
FXO Connector Pinouts on page 47
Required Cables
The CTP2000 2W-FXS and 2W-FX0 interface modules require the use of double-shielded
cables (copper braid plus aluminum mylar foil) to ensure EMI Compliance.
RTM Pinout Locations
Figure 27 on page 46 shows the pinout locations for both the CTP2000 2W-FXS and
2W-FXO interface modules.
45Copyright © 2017, Juniper Networks, Inc.
Chapter 6: Cable and Pinout Specifications

Juniper CTP2000 Series Specifications

General

Brand	Juniper
Model	CTP2000 Series
Category	Network Hardware
Language	English