Keithley 2100 User Manual

2100-900-01 Rev. D / September 2011 Return to Section Topics 4-15
Model 2100 6 1/2-Digit Resolution Digital Multimeter User’s Manual Section 4: Front Panel Operations
Figure 4-9
Toggle auto triggering on and off
Internal immediate trigger mode (remote interface operation only)
Definition
The Internal Immediate Trigger mode is only available through the remote interface operation, and
is the default setting for the remote interface. When the meter is in Immediate Trigger mode, a
trigger will be generated immediately after the meter goes into a "wait for event" state.
How to use immediate trigger
Use the following command from your PC terminal to set the Internal Immediate Trigger:
TRIGger:SOURce IMMediate
Single Trigger mode (accessible only through the front panel)
Definition
Single Trigger mode takes one reading (or the specified number of readings) each time you press
the SINGLE key (refer to “
Trigger setting” for details on setting the number of samples on each
trigger). When the TRIG annunciator on the display is lit, the meter is ready for the next trigger
event. Single Trigger mode is only available through the front-panel.
How to use Single Trigger
First select the measurement function, and then press the SINGLE key on the front panel to set
the trigger mode (refer to
Figure 4-10).
FILTER
NEXT
PREV
DIGITS
RATIO
%
MIN/MAX
NULL
ESC
ENTER
AUTO
SINGLE
TRIGGER
STORE
RECALL
LOCAL
SHIFT
CONFIG
MENU
AUT O
DCV
ACV
22
FREQ
CONT
TEMP
4 WIRE
RATIO
V
INPUT
PEAK
200V
PEAK
HI
LO
PEAK
500V
3A
RMS
INPUTS
3A 250V
FRONT/REAR
AMPS
R
1000V
REF
CAT 1000V
CAT 600V
LOCK
SETUP
ACV
22
FUNCTION
DCI ACI
4
PERIOD
LIMITS MX+B
dB
EXTRIG
HOLD
MATH
TRIGGER MEMORY
dBm
RANGE
DISPLAY
NEXT
PREV
POWER
OFF
ON
SENSE
F
TRIGGER
AUTO

Keithley 2100 Specifications

General

Brand	Keithley
Model	2100
Category	Multimeter
Language	English