11
11-88 bizhub 350/250
Specifying restrictions for registering fax addresses and printing re-
ports and specifying how one-touch dial recipients are displayed (mode
477)
Specify whether or not fax addresses can be registered and reports can be
printed by users. In addition, specify whether or not one-touch dial informa-
tion is displayed in screens and reports.
Settings at time of purchase
Specifying the setting
During the production of this unit, the settings in the shaded cells were se-
lected. The numbers on the right side indicate the page numbers with de-
scriptions for the corresponding function.
*1 If bit 6 is set to “1”, the settings will not be applied if bit 5 is set to “1” (not
displayed). If you do not wish to display the fax number or address of the re-
cipient, bit 6 must also be set to “1” (settings can only be specified in Admin-
istrator mode).
*2 If the recipient is directly specified from the Direct Input tab, the recipient
is displayed, even if “1” (not displayed) is selected.
Bits 7 6 5 4 3 2 1 0
Setting 0 0 0 0 0 0 0 0 (HEX: 00)
Bit Description Setting Description Page refer-
ence
7 -----------------------
0 *Do not change this bit. ----------
6 Specifies whether
settings for register-
ing fax addresses or
printing reports can
be specified by only
the administrator or
also by the user
0 Settings can also be
specified by users.
p. 11-45
1 Settings can only be
specified in Administrator
mode.
5 Specifies whether or
not only recipient
names are displayed
(and the fax number
or address is not
displayed) in reports
and Job List screens
and when a one-
touch dial button is
touched
*
1,
*
2
0 Displayed ----------
1 Not displayed
4, 3, 2, 1, 0 -----------------------
00000 *Do not change these
bits.
----------
To Next Page
Loading...
Need help?
General
