Safety
13
Pos: 8.6.11 /BA/Si cherheit/Hydraulikan lage @ 2\mod_12035036919 86_78.docx @ 66225 @ 2 @ 1
3.6 Hydraulic system
1 The hydraulic system is pressurised!
2 When connecting hydraulic cylinders and motors, make sure the hydraulic hoses are
connected as specified!
3 When connecting the hydraulic hoses to the tractor hydraulics, make sure that the
hydraulics of both the tractor and the implement have been depressurized!
4 In the case of hydraulic connections between tractor and machine, the coupling sleeves and
plugs should be marked to ensure a proper connection! If the connectors are interchanged,
the function will be reversed (e. g. raising/lowering) - Risk of accident!
5 When searching for leaks, use suitable aids to avoid the risk of injury!
6 Liquids escaping under high pressure (hydraulic oil) can penetrate the skin and cause
serious injury! Seek medical help immediately should injuries occur! Danger of infection!
7 Before working on the hydraulic system, depressurise the system and switch off the engine!
Pos: 8.6.12 /BA/Si cherheit/Hydraulikan lage Zusatz Alterung der Hydraulikschlauc hleitungen @ 3\mod_12045 52944856_78.doc x @ 70772 @ @ 1
8 Check the hydraulic hose lines at regular intervals and replace them if damaged or worn!
The new hoses must fulfill the technical requirements set by the manufacturer of the
implement!
Pos: 8.6.13 /BA/Si cherheit/Wartung/ Wartung Mäher mit Gasspeic her+ Auswechseln von Arbei tswerkzeugen @ 0\mod_11 95647075607_78. docx @ 1442 @ 2 @ 1
3.7 Maintenance
1 Always make certain that the drive and the engine are switched off before doing any
repairs, maintenance or cleaning! - Remove the ignition key!
2 Regularly check that nuts and bolts are properly seated and tighten if necessary!
3 When carrying out maintenance work on a raised mowing unit, always use suitable means
to secure it against falling.
4 When replacing working tools with cutting edges, use suitable tools and gloves!
5 Oils, greases and filters must be disposed of correctly!
6 Always disconnect the power supply before working on the electrical system!
7 If protective devices and guards are subject to wear, check them regularly and replace them
in good time!
8 When performing electrical welding work on the vehicle and mounted devices, turn the
power supply off at main battery switch or disconnect generator cable and battery!
9 Replacement parts must at least comply with the technical requirements set by the
manufacturer of the implements! This is guaranteed by original KRONE spare parts!
10 Only use nitrogen for filling pneumatic accumulators - risk of explosion!
Pos: 8.6.14 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
