74
15 Index
A
Abrasion Limit ..................................................... 57
Adjusting Skids ................................................... 70
Adjusting the Compensation Springs ................. 40
Adjusting the cutting height ................................ 41
After Shearing Off ............................................... 64
Aligning the Cutter Bar ........................................ 50
Angular gearbox ................................................. 48
Attached devices ................................................ 12
B
Before mowing .................................................... 34
Before the Start of the New Season ................... 69
Blade Changing on Cutting Discs ....................... 58
Blade Quick-Fit Device ................................. 54, 60
Blade screw connection ...................................... 53
Blade Screw Connection .................................... 59
C
Checking the Cutter Blades and Blade Holder ... 52
Checking the First fitting ..................................... 25
Clamp and Buffer ................................................ 33
Commissioning ................................................... 18
Compensation Spring(s) ..................................... 39
Connecting the hydraulic lines ............................ 30
Contact ................................................................. 6
Conversion for mowing steep slopes .................. 72
Conversion to narrower swathing ....................... 71
Cutter Blades ...................................................... 52
D
Dangers in Case of Non-compliance with the
Safety Instructions .......................................... 11
Detaching the machine ....................................... 36
Deviating Tightening Torques ............................. 46
Disposal of the machine ..................................... 73
Driving and Transport ......................................... 32
F
Filling Quantities and Lubrication Designations for
Gearboxes ...................................................... 47
First installation ................................................... 18
Fitting the guard cloths ....................................... 19
H
Hydraulic system ................................................ 13
Hydraulics ........................................................... 30
I
Identification Plate ................................................ 7
Identifying Symbols in the Operating Instructions 9
Inadmissible Modes of Operation ...................... 14
Information Required for Questions and Orders .. 7
Install the PTO shaft .......................................... 27
Installation of Weiste triangle ............................. 20
Intended use ........................................................ 8
Introduction .......................................................... 6
L
Lighting ........................................................ 21, 32
Lighting connection ............................................ 29
Lower suspension arm ....................................... 24
Lubrication Chart ................................................ 67
M
Maintenance ................................................ 13, 43
Maintenance – lubrication chart ......................... 66
Metric Thread Screws with Control Thread ....... 44
Metric Thread Screws with Countersunk Head
and Hexagonal Socket ................................... 45
Metric Thread Screws with Fine Thread ............ 45
Mounting and adjusting the relief springs .......... 28
Mounting onto the Tractor .................................. 23
Moving the guards into the working position ..... 35
Mower Drive Gearbox ........................................ 49
O
Oil Level Check and Oil Change Intervals
(Gearboxes) ................................................... 47
Oil level che
ck and oil change on the cutter bar 50
Operation ........................................................... 34
P
Periodical Inspection of the Cutting Discs / Blade
Drums ............................................................ 56
Periodical Inspection of the Leaf Springs .......... 55
Personnel Qualification and Training ................. 11
Placing in Storage .............................................. 68
Position of the Adhesive Safety Stickers on the
Machine ......................................................... 16
Preparation on the front-mounted disc mower .. 20
PTO operation .................................................... 12
PTO shaft ..................................................... 26, 66
Purpose of Use .................................................... 6
R
Removing the compensation spring(s) .............. 36
Replacing the linings .......................................... 61
Rotary hub with shear fuse (optional) ................ 62
To Next Page
Loading...
Need help?
General
