Safety
15
Pos: 8.8 /BA/Sicher heit/EasyCut/Sic herheit Einführung EasyC ut @ 3\mod_12045537639 50_78.docx @ 70812 @ 2 @ 1
3.10 Introduction
The disc mower is equipped with all safety devices (protective devices). However, it is not
possible to eliminate all potential hazards on this machine as this would impair its full functional
capability. Hazard warnings are attached to the machine in the relevant areas to warn against
any dangers. The safety instructions are provided in the form of so-called warning pictograms.
Important information on the position of these safety signs and what they mean is given below!
Pos: 8.9 /BA/Sicher heit/2. Vorangestell te Warnhinweise/W arnung - Beschädigte oder unle sbare Warnbildzeic hen @ 120\mod_134330578 9479_78.docx @ 1099853 @ @ 1
WARNING!
Danger of injury on machine parts if danger zones have not been marked when warning
pictograms are missing, damaged or illegible.
Danger of injury due to dangerous parts and other residual risks as users or third parties enter
the danger area or reach into it as they are not aware of the danger.
• Immediately replace damaged or illegible labels.
• Following repair work, always attach appropriate adhesive safety labels to all the replaced,
modified or repaired components.
• Never clean areas carrying an adhesive safety label using a high-pressure cleaner.
Familiarise yourself with the statement of the warning pictograms. The adjacent text and
the selected location on the machine provide information on the special danger spots on
the machine.
Pos: 8.10 /Layout Module /---------------Seitenumbruch---------------- @ 0\mod_119617531122 6_0.docx @ 4165 @ @ 1
To Next Page
Loading...
Need help?
General
