POWERPACK HV, BATTERY CHARGER 17
113
Guideline
Free space at the front
and rear side of the bat-
tery charger
≥ 20 cm (≥ 7.9 in)
– Use the battery charger in the temperature range permit-
ted.
Guideline
Ambient temperature −15 … 50 °C (5 …
122 °F)
– Ensure that the power plug for the battery charger always
remains easily accessible.
17.6 Checking residual current protection switch (Option: Battery charger 1)
K00031-10
Warning
Risk of injury There is a risk of electric shock with a
faulty residual current protection switch.
– Before each use of the charger check the residual
current protection switch.
– Do not use the battery charger if the test procedure
was not successful.
– Connect the mains plug to the mains connection.
–
Press the
1
button.
The operating display lights up red.
–
Press the
2
button.
The operating display goes out.
The residual current protection switch can be used.
– Disconnect power plug from mains connection.
17.7 Charging the Powerpack HV
Note
Material damage The power supply will be damaged in the event of an overload.
In charge mode Fast, a steady current of at least 13 A is required.
In charge mode Normal, a steady current of at least 10 A is required.
– Ensure that the power outlet can supply the steady current required and is protected by a suitable fuse.
Note
Environmental hazard A lithium-ion battery (Powerpack) contains components and elements that are
harmful to the environment.
– Never throw a Powerpack into the household trash.
– Dispose of the Powerpack properly and in compliance with the applicable regulations. (Your authorized
KTM workshop will be glad to help.)
To Next Page
Loading...
Need help?
General
