23 TROUBLESHOOTING
136
23.2 Troubleshooting of the battery charger
F03150-10
The faults are indicated by LED
1
on the battery charger. All of
the following blink codes are displayed on the charger and refer to
the charger itself.
Tip
The first step to take in case of any fault is to switch off
the battery charger, wait for 15 seconds, and then switch it
back on.
If a fault is not eliminated by the measures specified here,
or a blink code is not listed, an authorized KTM workshop
will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Faults Possible cause Action
Blink code 11 on battery
charger
Fault in the charging cable – Check the charging plug and charging
cable for external damage and dirt and
reconnect.
Blink code 12 on battery
charger
Fault in the charging cable – Check the charging plug and charging
cable for external damage and dirt and
reconnect.
Blink code 13 on battery
charger
Fault in the charging cable – Check the charging plug and charging
cable for external damage and dirt and
reconnect.
Blink code 51 on battery
charger
Overtemperature of the battery
charger
– Let the charger cool down.
– Continue charging in a cooler location.
Blink code 63 on battery
charger
Fault in the supply voltage – Use the Normal charging mode.
– Choose a socket closer to the central
supply.
Blink code 65 on battery
charger
Fault in the supply voltage – Use the Normal charging mode.
– Choose a socket closer to the central
supply.
To Next Page
Loading...
Need help?
General
