TROUBLESHOOTING 23
137
23.3 Troubleshooting Powerpack HV on the battery charger
F03150-11
The faults are indicated by LED
1
on the battery charger. All of
the following blink codes are displayed on the battery charger and
refer to the Powerpack HV.
Tip
The first step to take in case of any fault is to switch off
the battery charger, wait for 15 seconds, and then switch it
back on.
If a fault is not eliminated by the measures specified here,
an authorized KTM workshop will be happy to help you.
Info
The pause between the signals of the 1st digit is 0.25 sec-
onds.
The pause between the 1st and 2nd digits is 1 second.
The pause between the signals of the 2nd digit is also
0.25 seconds.
The pause until the blink code repeats is 3 seconds.
Faults Possible cause Action
Blink code 11 on battery
charger
Charging fault – Check the charging plug and charging
cable for external damage and dirt and
reconnect.
Blink code 33 on battery
charger
Overtemperature of the
Powerpack HV
– Allow the Powerpack HV to cool down.
Blink code 34 on battery
charger
Undertemperature of the
Powerpack HV
– Place the Powerpack HV in a warmer
location and allow it to warm up.
– Continue charging in a warmer loca-
tion.
Blink code 36 on battery
charger
Undertemperature of the
Powerpack HV
– Place the Powerpack HV in a warmer
location and allow it to warm up.
– Continue charging in a warmer loca-
tion.
Blink code 64 on battery
charger
Charging cable detected in
activated vehicle
– Switch off the main switch on the vehi-
cle and restart charging.
Blink code 65 on battery
charger
Fault in the charging cable – Check the charging plug and charging
cable for external damage and dirt and
reconnect.
Blink code 66 on battery
charger
Powerpack HV charging level
too high for charging mode
Storage
– Empty the Powerpack HV to below
30%.
Blink code 73 on battery
charger
Powerpack HV not enabled – Contact an authorized KTM workshop.
To Next Page
Loading...
Need help?
General
