POWERPACK HV, BATTERY CHARGER 17
117
Finishing work
– Lock the seat. ( p. 69)
17.8 Charging the Powerpack HV in charging mode Storage
Note
Material damage The power supply will be damaged in the event of an overload.
In the Storage charging mode, a steady current of at least 10 A is required.
– Ensure that the mains connection can supply the steady current required and is protected by a suitable fuse.
Note
Environmental hazard A lithium-ion battery (Powerpack) contains components and elements that are
harmful to the environment.
– Never throw a Powerpack into the household trash.
– Dispose of the Powerpack properly and in compliance with the applicable regulations. (Your authorized
KTM workshop will be glad to help.)
Info
The charging level of the Powerpack HV must be below 30 % before the Storage charging mode can be
used.
If the temperature of the Powerpack HV exceeds the permissible value while it is being charged, the bat-
tery charger stops charging. All LEDs and the LEDS for the current charging level alternately light up every
second.
After the temperature of the Powerpack HV returns to the permissible range, charging is resumed automat-
ically.
Preparatory work
– Position the battery charger. ( p. 111)
C00815-10
Main work
–
Remove charging socket protection cap
1
.
Warning
Risk of injury The intrinsic safety of the Powerpack
HV can only be guaranteed if the original battery
charger is used.
The Powerpack HV may only be charged with the orig-
inal battery charger.
– Only use the original battery charger to charge the
Powerpack HV.
– Connect the battery charger to the Powerpack HV. Observe
plug marking
A
.
To Next Page
Loading...
Need help?
General
