21 CLEANING, CARE
130
21.1 Cleaning the motorcycle
Note
Material damage The vehicle and the Powerpack HV are not suitable for pressure cleaning.
The high pressure forces water into the electrical components, connectors, bearings, etc. As a result, compo-
nents may be damaged or destroyed.
– Never clean the vehicle and the Powerpack HV with a pressure cleaner or a powerful jet of water.
Note
Material damage Water or dirt damage or destroy components.
– Always mount the protection cap after you have removed the Powerpack HV.
– Do not point the jet of water toward the battery discharge plug, even if the protection cap has been mounted.
Note
Environmental hazard Hazardous substances cause environmental damage.
– Dispose of oils, grease, cleaning agents, brake fluid etc. properly and in compliance with the applica-
ble regulations.
Info
To maintain the value and appearance of the motorcycle over a long period, clean it regularly.
Avoid direct sunshine when cleaning the motorcycle.
Preparatory work
– Deactivate the vehicle. ( p. 43)
– Fold the seat up. ( p. 69)
– Remove the Powerpack HV. ( p. 108)
– Mount the protection cap. ( p. 71)
401061-01
Main work
– Remove the coarse dirt particles with a gentle water jet.
– Spray the heavily soiled parts with a normal commercial motor-
cycle cleaner and clean using a brush.
Motorcycle cleaner ( p. 145)
Info
Use warm water containing normal motorcycle cleaner
and a soft sponge.
Never apply motorcycle cleaner to a dry vehicle; always
rinse the vehicle with water first.
– After rinsing the motorcycle with a gentle spray of water, allow
it to dry thoroughly.
Warning
Danger of accidents Moisture and dirt impair the
brake system.
– Brake carefully several times to dry out and remove
dirt from the brake linings and the brake discs.
– Lubricate all sliding points and pivot points.
– Clean the chain. ( p. 72)
To Next Page
Loading...
Need help?
General
