Kubota D1703-BE User Manual

S.l ENGINE BODY 92.4mrn STROKE SERIES WSM, 01098
[6] FLYWHEEL AND CRANKSHAFT
01670P
\-
I
I OOOAl09P018
Flywheel
1. Lock the flywheel not to turn using the flywheel
2. Remove the flywheel screws, except for two which
3. Set a flywheel puller (Code No: 07916-3201 I), and
(When reassembling)
0 Apply engine oil to the flywheel bolt.
stopper.
must be loosened and
left as they are.
remove the flywheel.
Bearina
Case Cover and Crankshaft
II NOTE
0 Before disassembling, check the side clearance of
1. Remove the bearing case cover (3).
2. Remove the bearing case screw 2 (5).
3. Pull out the crankshaft.
(When reassembling)
1 IMPORTANT
0 install the crankshaft sub assembly, aligning the
screw hole of main bearing case
2 (2) with the
screw hole of cylinder block
(1).
0 Apply engine oil to the seat and thread of bearing
case screw 2 (5) and tightening it.
0 Install the bearing case cover (3) to position the
casting mark
"UP" (4) on it upward.
0 Tighten the bearing case cover mounting screws
with even force on the diagonal
line.
crankshaft. Also check it during reassembly.
(1) Cylinder Block
(2) Main Bearing Case
2
(3) Bearing Case Cover
(4) Casting Mark "up"
(5) Bearing Case Screw 2
C112F052
s-7 1

Kubota D1703-BE Specifications

General

Brand	Kubota
Model	D1703-BE
Category	Engine
Language	English