5.1
ENGINE
BODY
92.4mm STROKE
SERIES
WSM,
0109A
[SI
PISTON AND CONNECTING ROD
C112FO44
I
C112F045
Oil
Fan and Oil Strainer
1.
Remove the oil pan and strainer
(1).
(When reassembling)
0
After cleaning the oil strainer, install
it.
0
Install the oil strainer
(I),
being careful not to
damage the O-ring.
0
Apply
a
liquid gasket (Three Bond
1215
or
equivalent) to both sides of the oil pan gasket.
0
To avoid uneven tightening, tighten mounting
bolts in diagonal order from the center.
(1) Oil Strainer
Piston
1.
Turn the flywheel, and bring the piston to the
2.
Remove the connecting rod bolt and take off the
bottom dead center.
connectin rod cap.
dead center.
a
hammer.
3.
Turn the
f
4
ywheel, and bring the piston to the top
from the bottom of the crankcase wit
Yl
the grip of
4.
Pull out the piston upward by light1 tapping
it
(When reassembling)
0
Apply engine oil to the piston, piston ring and
cylinder bore.
0
When inserting the piston into
the
cylinder,
face
the number
(1)
on the connecting rod to the
in'ection pump.
0
Align
the
number
(I)
on
the
connecting rod and
connecting rod cap.
0
Apply engine oil
to
the crank pin bearings and
bolts.
Tightening
torque
Connecting
rod bolt
I
36.3 to 41.2 N.m
3.7 to 4.2 kgf.m
Non-
I I
26.6 to 30.4ft-lbs
44.1
to
49.9 Nm
4.5
to
5.0 kgf-m
32.5 to 36.2 ft-lbs
11900F103~0
5-67
(1)
Align the number
(A)
lop
Ring
Gap
(6)
Second
Ring
Cap
(C)
Oil Ring
Gap
(D)
Piston
Pin
Hole
To Next Page
Loading...
Need help?
General
