S.1
ENGINE
BODY
92.4mm
STROKE SERIES
WSM,
01092
DISASSEMBLING AND ASS
EM
B
LI
NG
[I]
DRAINING WATER AND
OIL
NOTE
0
Some types
of
gearcases are provided
with
an oil filter port. When the cylinder head has been
reassembled or when the valve clearance has been readjusted, apply an enough amount of oil to
the
intake and exhaust valves, push rod and rocker arm
just
before fitting the head cover
in
position.
Draining Cooling Water and Engine
Oil
A
CAUTION
0
Never remove radiator cap until cooling water
temperature
is
below
its
boiling point. Then
loosen cap slightly to the stop to relieve any
excess pressure before removing cap completely.
1.
Prepare a bucket. Open the drain cock to drain
cooling water.
2.
Prepare an oil pan. Remove the drain plug
to
drain engine
oil
in
the pan.
[2]
EXTERNAL COMPONENTS
Air Cleaner, Muffler and others
1.
Remove the air cleaner and muffler.
2.
Remove the fan, fan belt, alternator and starter.
(When reassembling)
0
Install the muffler gasket
so
that
its
steel side face
the muffler.
0
Check to see that there are no cracks on the belt
surface.
H
IMPORTANT
0
After reassembling the fan belt, be sure to adjust
the fan belt tension.
A
109POO
s-55
To Next Page
Loading...
Need help?
General
