S.G
GENERAL
92.4rnrn STROKE SERIES WSM, 01092
[2]
GENERAL PRECAUTION
EEL-
\
SGOOF002
0
During disassembly, carefully arrange removed
parts in
a
clean
area to prevent confusion later.
Screws, bolts and nuts should be replaced in their
original position to prevent reassembly errors.
0
When special tools are required, use Kubota’s
genuine special tools. Special tools which are not
frequently used should be made according to the
drawings provided.
0
Before disassembling or servicing live wires, make
sure to always disconnect the grounding cable
from
the
battery first.
Remove oil and dirt from parts before measuring.
0
Use
only KUBOTA genuine parts for parts
replacement to maintain engine performance and
to ensure safety.
0
Gaskets and O-rings must be replaced during
reassembly. Apply grease
to
new O-rings or oil
seals
before assembling.
0
When reassembling external or internal snap
rings, position them
so
that
the
sharp edge faces
against the direction from which force
is
applied.
0
Be sure to perform run-in the serviced or
reassembled engine. Do not attempt to give heavy
load
at
once, or serious damage may result to
the
engine.
A
CAUTION
0
Certain components used in
this
engine (cylinder
head-gasket, exhaust gasket, etc.) contain
asbestos. Handle
with
care according to safety
regulation.
(1)
Grease
(2) Force
(3)
Place the Sharp Edge against the Direction
of
Force
[A]
External Snap Ring
[E]
Internal Snap Ring
s-3
To Next Page
Loading...
Need help?
General
