M.l
ENGINE
BODY
92.4mm STROKE
SERIES
WSM,
01092
161 CAMSHAFT
A109F009
[7]
FLYWHEEL
A109F010
A109F011
[8]
ROCKER ARM
C059F055
The camshaft
(3)
is
made of special
cast
iron and
the
journal and cam sections are chilled to resist
wear.
The
journal sections are force-lubricated. The
movement of
the
injection pump. The fuel camshaft
is
made of carbon steel and the cam sections are
quenched and tempered to provide greater wear
resistance.
(1)
Cam Gear
(2)
Camshaft Stopper
(3)
Camshaft
(4) Injection Pump Gear
(5)
Fuel Camshaft
fuel camshaft
(5)
controls
the
reciprocating
L
The flywheel stores
the
rotating force
in
the
combustion stroke as
inertial
energy, reduces
crankshaft rotating speed fluctuation and maintains
the smooth rotating conditions.
The flywheel periphery
is
inscribed with
the
marks
showing fuel injection timing
angle
lines
and top
dead center mark
TC.
The
flywheel
has
gear teeth around
its
outer rim,
which mesh with the drive pinion of the starter.
(1)
Crankshaft
(2) Flywheel
(3)
Flywheel Screw
The
rocker arm assembly includes
the
rocker arms
(l),
rocker arm brackets (4) and rocker arm shaft
(5)
push rods to an openklose movement of
the
inlet
and exhaust
valves.
Lubricating oil pressurized through the bracket to
the rocker arm shaft, which serves
as
a fulcrum so
that
the
rocker arm and
the
entire system are
lubricated sufficiently.
(1)
Rocker Arm
(4)
Rocker Arm Bracket
(2)
Lock Nut
(5)
Rocker Arm Shaft
(3)
Adjusting Screw
M
-7
To Next Page
Loading...
Need help?
General
