KYMCO DINK 200i Service Manual

Name: KYMCO DINK 200i
Brand: KYMCO
Rating: 5 (1 reviews)

400 pages

To Next Page

To Previous Page

7. CYLINDER/PISTON

7-4

DINK 200i/125

CYLINDER AND PISTON

REMOVAL

Remove the cylinder head (refer to

“CYLINDER HEAD” section in the chapter

6).

Remove the water hose (1) from the cylinder.

Remove the two cylinder bolts/washers (2).

Remove the cylinder.

Remove the cylinder gasket (4) and dowel

pins (3).

Clean any gasket material from the cylinder

surface.

Remove the piston pin clip (6).

Press the piston pin (5) out of the piston and

remove the piston (7).

Place a clean shop towel in the crankcase

to keep the piston pin clip from falling

into the crankcase.

Questions and Answers:

Need help?

Do you have a question about the KYMCO DINK 200i and is the answer not in the manual?

General