12. COOLING SYSTEM
12-18
DINK 200i/125
WATER TEMPERATURE
SENSOR
REMOVAL
Remove the luggage box (refer to the
“FRAME COVERS
REMOVAL/INSTALLATION” section in
the chapter 2).
Drain the coolant (refer to the “COOLANT
REPLACEMENT” section in this
chapter).
Disconnect the water temperature sensor
connectors (1).
Remove the water temperature sensor (2)
from thermostat.
INSPECTION
Connect the water temperature sensor to the
ohmmeter and dip it in oil contained in a
pan which is placed on an electric heater.
Gradually raise oil temperature while
reading the thermometer in the pan and the
ohmmeter connected. If the resistance
measured is out of specification, replace the
temperature gauge with a new one.
Temperature Standard resistance
50ºC 123.9• •478.9 $
100ºC 26• •29.3 $
Senso
Handle the water temperature sensor
carefully as it is vulnerable to impact.
Do not allow the water temperature
sensor and the thermometer to come in
contact with the bottom of the pan.
• •
To Next Page
Loading...
Need help?
General