14. DINK 200 i: FUEL SYSTEM (Auto Control Fuel Injection System)
14-42
(Using diagnostic tool)
Enter RECIVE SIGNAL MENU and then
read data in page 01 (refer to the “RECIVE
SIGNAL MENU (USING DIAGNOSTIC
TOOL)” section in this chapter).
Read the data:
Engine Temp. (°C)
Engine Temp. sensor volt
FUEL INJECTOR
REMOVAL
Disconnect the connector from fuel injector.
Remove the bolt, then remove injector and
tension seal.
Remove the spring clip and then remove the
fuse hose joint.
To Next Page
Loading...
Need help?
General