14. DINK 200i: FUEL SYSTEM (Auto Control Fuel Injection System)
14-41
WATER TEMPERATURE
SENSOR (WTS)
REMOMAL
Disconnect the WTS connector, then remove
WTS.
INSTALLATION
Replace a new washer.
Install and tighten the WTS to the specified
torque.
Torque: 2 kgf-m (20 N-m, 14 lbf-ft)
Connect the WTS connector.
INSPECTION
(Using a commercially available
multimeter)
Measure the throttle position sensor
resistance.
Standard:
703.8±40.9 " (60°C)
206.7±15.1 " (90°C)
111.1±7.8 " (120°C)
To Next Page
Loading...
Need help?
General