KYMCO DINK 200i Service Manual

4. LUBRICATION SYSTEM
4-3
DINK 200i/125
Snap Ring
Bolt
s
Oil Pump Driven Gea
r
Oil Separato
r
OIL PUMP
REMOVAL
Remove the flywheel and driven gear (refer
to the “STARTER CLUTCH” section in the
chapter 10).
Remove the bolt and then oil separator cover.
Pry the snap ring off and remove the oil pump
driven gear, then remove the oil pump drive
chain.
Remove the two oil separator bolts to remove
the oil pump.
Oil Se
p
arator Cove
r
Oil Pump
When removing and installing the oil
pump, use care not to allow dust or dirt
to enter the engine.
Ϡ

KYMCO DINK 200i Specifications

General

Brand	KYMCO
Model	DINK 200i
Category	Scooter
Language	English