13. DINK 125:FUEL SYSTEM/CARBURETOR/
FUEL PUMP/ FUEL TANK
13-24
DINK 200i/125
FUEL STRAINER
REMOVAL/INSTALLATION
Remove the center cover (refer to the
“FRAME COVERS
REMOVAL/INSTALLATION” section in
the chapter 2).
Disconnect the fuel hoses (1) and remove
the fuel strainer (2).
Install the fuel strainer with its arrow mark
toward the fuel pump.
INSPECTION
Inspect if the fuel strainer is clogged and
clean it with compressed air.
When removing the fuel strainer, do not
allow flames or sparks near the working
area and drain the residual gasoline into a
container.
Ϡ
To Next Page
Loading...
Need help?
General