2-21
Installing and Setting up the Machine > Energy Saver function
4 Press the [ā²] or [ā¼] key to select [Sleep Rules], and press the [OK] key.
2
Set the Sleep rule.
1 Press the [ā²] or [ā¼] key to select the function to be set, and press the [OK] key.
[Card Reader] is displayed when the optional Card Authentication Kit is installed.
[FAX] is displayed only on products with the fax function installed.
2 Press the [ā²] or [ā¼] key to select [Off] or [On], and press the [OK] key.
Repeat steps 2-1 to 2-2 to set for a different function.
Sleep Level (Energy Saver and Quick Recovery) (models except for Europe)
For sleep level, you can toggle between the following two modes: Energy Saver mode and Quick Recovery mode. The
default setting is Energy Saver mode.
Energy Saver mode reduces power consumption even more than Quick Recovery mode, and allows Sleep Mode to be
set separately for each function. The time required for the machine to wake up from power save mode and resume
normal operation will be longer than for Quick Recovery mode. The ID card cannot be recognized.
Quick Recovery mode recovers from sleep mode quicker than Energy Saver mode. To resume, press any key on the
operation panel. If print data is received during Sleep, the machine automatically wakes up and starts printing.
For more information on Sleep Level settings, refer to Sleep Level (models except for Europe) on page 8-25
.
Follow the steps below to select the sleep level and use Energy Saver mode for each function.
1
Display the screen.
1 Press the [System Menu/Counter] key.
To Next Page
Loading...
Need help?
General
