Lamtec UI400 User Manual

278
12 Appendix
12 Appendix
12.1 CP Default Configuration
For the general functionality of the communication processor (CP), a standard configuration
is required, which becomes effective in case of invalid CP parameter queries or invalid CP pa-
rameter configurations. This is listed below:
Parameter Default Value Remarks
SPS name PLC <host name> Everything is valid, up to 32 characters
IP address 192.168.11.200 Invalid: X.X.X.0 or X.X.X.255
Subnet mask 255.255.255.0 Invalid: 0.0.0.0
Gateway 192.168.11.4 Everything is valid
Primary DNS 192.168.11.1 Everything is valid
Secondary DNS 192.168.11.4 Everything is valid
Host name cms00 Everything is valid, ASCII,
up to 15 characters
DHCP Enabled Valid: 0, 1
If DHCP is enabled but no DHCP server is
available, ’AutoIP’ is activated after a timeout
of 60 s. Random IP in the range of :
169.254.1.0 - 169.254.254.255
Subnet mask: 255.255.0.0
SNTP 217.79.179.106 Everything is valid, without SNTP = 0.0.0.0
SNTP interval 720 Min. -32768 ... 32767
LSB termination Enabled 0,1
LSB family 1 1, 2, 3, 4
Time zone UTC (0) -32768 ... 32767

Lamtec UI400 Specifications

General

Brand	Lamtec
Model	UI400
Category	Control Systems
Language	English