LAUNCH
32
It needs to be performed in the following cases:
When the gearbox is disassembled or repaired.
6.12 Headlight Matching (AFS RESET)
This function enables you to initialize the adaptive headlamp system.
6.13 Sunroof Initialization (SUNROOF)
This function enables you to set the sunroof lock off, closed when it rains, sliding / tilting sunroof
memory function, temperature threshold outside the car etc.
6.14 Suspension Level Calibration (SUS RESET)
This function enables you to adjust the height of the body.
It needs to be performed in the following cases:
1. When replacing the body height sensor, or control module in the air suspension system.
2. When the vehicle height is incorrect.
6.15 EGR Adaption
This function is used to learn the EGR (Exhaust Gas Recirculation) valve after it is cleaned or replaced.
6.16 Seats Calibration
This function is applied to match the seats with memory function that are replaced and repaired.
6.17 Tyre Reset
This function is used to set the size parameters of the modified or replaced tire.
6.18 Coolant Bleed
Use this function to activate the electronic water pump before venting the cooling system.
6.19 AdBlue Reset
After the diesel exhaust treatment fluid (car urea) is replaced or filled up, urea reset operation is
required.
6.20 NOx Sensor Reset
NOx sensor is a sensor used to detect the content of nitrogen oxides (NOx) in engine exhaust. If the
NOx fault is re-initialized and the NOx catalytic converter is replaced, it is necessary to reset the
catalytic converter learned value stored in the engine ECU.
6.21 AC System Relearn/Initialization
AC system relearn/initialization must be performed when the vehicle AC ECU or actuator is replaced or
the ECU memory is lost.
To Next Page
Loading...
Need help?
General
