LAUNCH
40
9 Add-on Modules (Toolbox)
9.1 ADAS (Calibration)
This module enables you to effectively and accurately calibrate a wide range of camera-based &
radar-based driver assistance systems, e.g. the front camera for the lane departure warning system,
the radar sensor for the ACC (Adaptive Cruise Control) or the camera for adaptive headlights. It needs
to work with the specific ADAS calibration tool (sold separately).
For more details, please refer to the User Manual included with the module.
9.2 TPMS
This module allows you to configure the tablet as TPMS activation & diagnostic tool, which provides the
ability to trigger TPMS sensor, program TPMS sensor, perform the relearning procedure. It needs to
work with the compatible TSGUN device (sold separately).
For more details, please refer to the User Manual included with the module.
9.3 S2-2 Sensorbox
This module enables you to diagnose and simulate vehicle sensor faults quickly and conveniently. It
needs to work with the compatible S2-2 Sensorbox (sold separately).
For more details, please refer to the User Manual included with the module.
9.4 S2-2 Multimeter
This module allows you to measure the physical parameters such as voltage, resistance, frequency etc.
It utilizes the same hardware as the S2-2 Sensorbox.
For more details, please refer to the User Manual included with the S2-2 Sensorbox.
9.5 BST360 (Battery Tester)
This module allows you to fix battery detection faster and easier. It needs to work with the specific
Bluetooth battery tester (sold separately).
For more details, please refer to the User Manual included with the module.
9.6 Videoscope
This module allows you to check those unseen parts of engine, fuel tank, braking system. It needs to
work with the compatible Videoscope device (sold separately).
For more details, please refer to the User Manual included with the module.
9.7 Immobilizer Programmer
This module allows you to perform the read-write function for vehicle keys, EEPROM, MCU, and
EEPROM/FLASH of vehicle engine and gearbox ECU. It needs to work with the specific immobilizer
programmer (sold separately).
For more details, please refer to the User Manual included with the module.
To Next Page
Loading...
Need help?
General
