SAFETY INFORMATION GRT655/655L OPERATOR MANUAL
2-46 Published 3-23-2020, Control # 654-04
NOTE: The following checklist includes all features that
can be found on Grove cranes. Your crane may not
have some features.
Overload less than 25%
1 Lift Cylinder Inspect for leaking.
2
Turntable
Bearing
Check bolts for proper torque.
See topic in Swing section of
Service Manual.
3 Wire Rope Inspect all for damage.
See topic in Introduction section
of Service Manual.
Overload from 25% to 49%
1 Lift Cylinder Inspect for leaking.
2
Turntable
Bearing
Check bolts for proper torque.
See topic in Swing section of
Service Manual.
3 Wire Rope Inspect all for damage.
See topic in Introduction section
of Service Manual.
4 Hoist/Drums Inspect each for damage.
5 Hoist Brakes Brakes must hold rated line pull.
6
Bearing Main
Boom Pivot
Pin
Inspect for deformation, cracked welds.
7
Lift Cylinder-
lower mount
Inspect pin and welds.
8 Turntable Inspect for deformation, cracked welds.
9 Welds Inspect for cracks.
10 Paint
Inspect for cracked paint which could indicate twisted,
stretched, or compressed members.
To Next Page
Loading...
Need help?
General
